Position: Sights and Optical Sensor Engineer

Position Requirements:   

Bachelor’s degree in electrical engineering, Computer Engineering (BSCE), Mechatronics or Robotics preferred with a minimum of 5 years of applicable experience. Fewer years will be considered with an advanced degree.  

Current experience with schematic capture software (PADS Designer preferred)  

Current experience with circuit simulation tools  

Current experience with circuit design reviews  

Current experience with PCB layout requirements  

Current experience with PCB layout design reviews  

Current experience Circuit Card Assembly (CCA) manufacturing processes  

Current experience using test equipment including DMM, oscilloscope, function generator, logic analyzer, current probes, etc.  

Knowledge of troubleshooting circuits using schematic  

Knowledge of serial communication interfaces  

Development of component/subsystem requirements from system requirements  

Ability to travel to supplier and government sites.  

Capable of getting a secret clearance desired  

ASR is needed to work inside tanks and military vehicles.  

Occasionally may need to lift and carry test equipment weighing 30 lbs.  

Strong interpersonal skills and ability to work with interdisciplinary teams.  

Ability to travel to supplier and government sites.  

Knowledge in many, but not all, of the following areas desired  

IPC and MIL standards  

Digital and Analog circuit design   

Power, thermal analysis, timing, biasing, voltage and current control, LED control, data packet deciphering, etc.  

Schematic development, component selection, circuit simulation, and PCB layout  

Engineering design, development, and analysis software Desired: MATLAB, MATHCAD, Mentor Graphics Schematic Capture, CAMView or CAM350         

Microprocessor based products including processors, chipsets, memory and bus interfaces, networking standards (PCI-xpress, DDR2, DDR3, USB, SATA, DVI, etc...)  

Microcontrollers including IDEs, configuration, coding, and programming desired: NXP family of microcontrollers.  

Industry interface standards and form factors (VITA42/46, COM Express, ETX, etc. ...)  

Networking Products, H/W, S/W, Switches, Routers, OSI layers  

Network Storage (NAS, SAN), Solid State and Rotating Drive technologies, Interfaces, and protocols (IDE, SATA, SCSI, Fibre Channel, NFS)  

Serial Interconnects, USB, CAN, RS422/485, etc.)  

Graphics/video interfaces (Ethernet, SDI, DVI, H

DMI, RS-170, etc.)  

FPGA Design and Simulation, VHDL  

EMI/EMC design practices and standards.  

C, C#, Visual Studio Suite  

Optical hardware and testing  

Experience with typical test equipment including Power Supplies, Oscilloscopes, DMM, Function Generators, Labview, etc. ……  

EOE (including Disability/Veterans)